Skip to Content

Changes for page 8. Control Setup Manual

Last modified by Iaroslav Platonov on 2026/06/09 11:18
From version 9.2
edited by Lana
on 2025/12/17 19:39
Change comment: There is no comment for this version
To version 7.6
edited by Lana
on 2025/12/17 19:38
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -80,30 +80,4 @@
80 80  
81 81  In the Remote **control **field, select the appropriate ASDU type for the control command from the drop-down list (see Fig. 3.1.4).
82 82  
83 -[[image:Screenshot 2025-12-17 at 16.38.45.png]]
84 -
85 -Figure 3.1.1. Setting telecontrol via Modbus protocol
86 -
87 -[[image:Screenshot 2025-12-17 at 16.39.12.png]]
88 -
89 -Figure 3.1.2. Setting telecontrol via IEC-104 protocol
90 -
91 -The following functions are available for the Modbus protocol:
92 -
93 -FC5 (0x05) - recording the value of one flag (Force Single Coil).
94 -
95 -FC6 (0x06) - recording the value to Preset Single Register.
96 -
97 -FC16 (0x10) - recording multiple registers, used to record a block of contiguous registers (1 to 123 registers) to a remote device (Write Multiple Registers)
98 -
99 -The** Value lenght** field specifies the number of registers to be recorded.
100 -
101 -The **Switch on address** field specifies the address of the register in the device memory where the enable command will be written. The address should be a non-negative integer.
102 -
103 -The **Switch off address** field specifies the register address in the device memory where the disable command will be written. The address should be a non-negative integer.
104 -
105 -The **Switch on value** and **Switch off value** indicate the value to be written to the register address to execute the disable command. The value can be specified in decimal, binary, octal, or hexadecimal (HEX) format. Decimal is written as a plain number, binary is prefixed with 0b or 0B, represents setting the two least significant bits to 1 and 0, octal is prefixed with 08, HEX is prefixed with 0x or 0X.
106 -
107 -The **Write by bitmask **field specifies the mask in decimal, binary, or HEX format.
108 -
109 -2) The
83 +
Screenshot 2025-12-17 at 16.38.45.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.Lana
Size
... ... @@ -1,1 +1,0 @@
1 -71.4 KB
Content
Screenshot 2025-12-17 at 16.39.12.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.Lana
Size
... ... @@ -1,1 +1,0 @@
1 -81.3 KB
Content