Skip to Content

Changes for page 8. Control Setup Manual

Last modified by Iaroslav Platonov on 2026/06/09 11:18
From version 7.4
edited by Lana
on 2025/12/17 19:35
Change comment: There is no comment for this version
To version 7.5
edited by Lana
on 2025/12/17 19:37
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,6 +1,6 @@
1 -CONTENT
1 += CONTENT =
2 2  
3 -~1. INTRODUCTION
3 += 1. INTRODUCTION =
4 4  
5 5  CENTO is a multifunctional software platform for data acquisition, processing and display. This manual describes how to configure the CENTO user tool Control.
6 6  
... ... @@ -8,9 +8,9 @@
8 8  
9 9  This manual describes how to configure the Control service, which is used to send control commands to the objects being controlled.
10 10  
11 -2. CONTROL USING WEB INTERFACE
11 += 2. CONTROL USING WEB INTERFACE =
12 12  
13 -2.1. Control using the device, tags editor
13 +== 2.1. Control using the device, tags editor ==
14 14  
15 15  A user with the appropriate permissions can control the object using the devices, tags, channels editor.
16 16  
... ... @@ -67,3 +67,12 @@
67 67  - reading settings as defined in the relevant configuration manuals,
68 68  
69 69  - settings for writing:
70 +
71 +* Remote control (discrete signal transmission to the device) for IEC-104 protocol: "Remote control is allowed", "Select before operate (SBO)", "Function", "Command duration", "Switch on address", "Switch on value", "Switch off address", "Switch off value", for Modbus TCP protocol: "Remote control is allowed", "Function", "Value length", "Switch on address", "Switch on value", "Switch off value", "Switch off address", "Write by bitmask";
72 +* Control (transmission of a positive integer to the device) for Modbus TCP protocol: "Record values", "Function", "Data type in device", "Address", "Byte order", conversion elements: "Physical value (lower limit)", "Physical value (upper limit)", "Value to record (lower limit)", "Value to record (upper limit)", for OPC DA protocol: "Record values", "Device Tag Data Type", conversion elements: "Physical value (lower limit)", "Physical value (upper limit)", "Value to record (lower limit)", "Value to record (upper limit)".
73 +
74 +1. The remote //control// function is available for Modbus TCP Modbus RTU over TCP) protocols (see Fig. 3.1.1) and IEC 104 (see Fig. 3.1.2).
75 +
76 +The position of the **Remote control is allowed **switch determines whether record commands can be sent to the device at the specified address.
77 +
78 +The position of the **Select before operate (SBO)** switch defines whether command selection is required prior to executing telecontrol commands.