Skip to Content

Changes for page 8. Control Setup Manual

Last modified by Iaroslav Platonov on 2026/06/09 11:18
From version 7.2
edited by Lana
on 2025/12/17 19:33
Change comment: There is no comment for this version
To version 7.4
edited by Lana
on 2025/12/17 19:35
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -51,3 +51,19 @@
51 51  Clicking **TC** also opens a password prompt window. After successful authentication, a command selection window appears (see Fig. 2.6). As with the Control, a confirmation window follows the selected command.
52 52  
53 53  [[image:Screenshot 2025-12-17 at 16.33.06.png]]
54 +
55 +Figure 2.6. Selecting command for remote control
56 +
57 +3. SETTING CONTROL
58 +
59 +3.1. Setting using WEB interface
60 +
61 +Setting control for tags transmitted via Modbus, OPC DA, or IEC-104 protocols is performed through the **Edit parameter** interface located under Settings > Devices, tags, channels, in the **Tags, channels** tab. In this interface, select the target device in the device tree by checking the box next to it. The device should be configured with one of the supported protocols: Modbus TCP, Modbus RTU over TCP, OPC DA, or IEC-104. To open the tag editing interface, click on the tag identifier or tag name in the general tag list.
62 +
63 +The interface includes protocol-dependent fields:
64 +
65 +- general settings described in the “Setup manual”,
66 +
67 +- reading settings as defined in the relevant configuration manuals,
68 +
69 +- settings for writing: