Skip to Content

Changes for page 8. Control Setup Manual

Last modified by Iaroslav Platonov on 2026/06/09 11:18
From version 47.2
edited by Lana
on 2025/12/17 20:38
Change comment: There is no comment for this version
To version 45.2
edited by Lana
on 2025/12/17 20:36
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -378,12 +378,4 @@
378 378  
379 379  In some devices, a single tag handles this function, while in others, two separate tags perform it. These tags are configured similarly to those used for direct remote control, differing only in the register address (see Fig. 3.3.23):
380 380  
381 -[[image:Screenshot 2025-12-17 at 17.37.11.png]]
382 -
383 -Figure 3.3.23. Tag configuration for telecontrol permission
384 -
385 -Thus, after adding the attributes //telecontrol_permit_on_ti// and //telecontrol_permit_off_ti//, configuring the tags, and assigning them to the IM object, CENTO software first sends the remote control permission command before transmitting the actual remote control command.
386 -
387 -4. RECOMMENDED SETTINGS AND SPECIAL CASES
388 -
389 -[[image:Screenshot 2025-12-17 at 17.38.23.png]]
381 +
Screenshot 2025-12-17 at 17.37.11.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.Lana
Size
... ... @@ -1,1 +1,0 @@
1 -105.5 KB
Content
Screenshot 2025-12-17 at 17.38.23.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.Lana
Size
... ... @@ -1,1 +1,0 @@
1 -67.7 KB
Content