Skip to Content

Changes for page 8. Control Setup Manual

Last modified by Iaroslav Platonov on 2026/06/09 11:18
From version 43.1
edited by Lana
on 2025/12/17 20:34
Change comment: Uploaded new attachment "Screenshot 2025-12-17 at 17.34.12.png", version {1}
To version 41.3
edited by Lana
on 2025/12/17 20:29
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -347,17 +347,5 @@
347 347  
348 348  Next, for the object with remote control commands, this attribute, should be enabled as shown in Fig. 3.3.19, and the command sending on the diagram should be tested.
349 349  
350 -[[image:Screenshot 2025-12-17 at 17.32.18.png]]
351 351  
352 -Figure 3.3.19. Configuring object for control without entering password
353 -
354 -=== 3.3.2. Configuring permission for remote control ===
355 -
356 -Before executing control commands, some devices require an initial permission signal to be sent to a dedicated register. This signal enables telecontrol functionality. Only after this permission is granted the device accepts and process the main telecontrol commands.
357 -
358 -To implement this type of telecontrol (TC) in CENTO, the following attributes are added to the object class (see Fig. 3.3.20):
359 -
360 -* **telecontrol_permit_on_ti** – permission to switch TC on;
361 -* **telecontrol_permit_off_ti** – permission to switch TC off.
362 -
363 363  
Screenshot 2025-12-17 at 17.32.18.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.Lana
Size
... ... @@ -1,1 +1,0 @@
1 -121.9 KB
Content
Screenshot 2025-12-17 at 17.34.12.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.Lana
Size
... ... @@ -1,1 +1,0 @@
1 -116.5 KB
Content