Changes for page 8. Control Setup Manual

Last modified by Iaroslav Platonov on 2026/06/09 11:18

From version 42.2

edited by Lana
on 2025/12/17 20:33

Change comment: There is no comment for this version

To version 42.1

edited by Lana
on 2025/12/17 20:32

Change comment: Uploaded new attachment "Screenshot 2025-12-17 at 17.32.18.png", version {1}

Summary

Page properties

Content

@@ -347,17 +347,5 @@
  Next, for the object with remote control commands, this attribute, should be enabled as shown in Fig. 3.3.19, and the command sending on the diagram should be tested.
--[[image:Screenshot 2025-12-17 at 17.32.18.png]]
--Figure 3.3.19. Configuring object for control without entering password
--
--=== 3.3.2. Configuring permission for remote control ===
--
--Before executing control commands, some devices require an initial permission signal to be sent to a dedicated register. This signal enables telecontrol functionality. Only after this permission is granted the device accepts and process the main telecontrol commands.
--
--To implement this type of telecontrol (TC) in CENTO, the following attributes are added to the object class (see Fig. 3.3.20):
--
--* **telecontrol_permit_on_ti** – permission to switch TC on;
--* **telecontrol_permit_off_ti** – permission to switch TC off.
--