Skip to Content

Changes for page 8. Control Setup Manual

Last modified by Iaroslav Platonov on 2026/06/09 11:18
From version 42.2
edited by Lana
on 2025/12/17 20:33
Change comment: There is no comment for this version
To version 41.2
edited by Lana
on 2025/12/17 20:27
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -341,23 +341,5 @@
341 341  
342 342  To skip password entry during remote control, as with control, an attribute named //Skip password// (any name can be used) is to be added. This attribute should have the  //skip_password// code and the //bool// type(see Fig. 3.3.18).
343 343  
344 -[[image:Screenshot 2025-12-17 at 17.27.52.png]]
345 345  
346 -Figure 3.3.18. Configuring the attribute for password-free control
347 -
348 -Next, for the object with remote control commands, this attribute, should be enabled as shown in Fig. 3.3.19, and the command sending on the diagram should be tested.
349 -
350 -[[image:Screenshot 2025-12-17 at 17.32.18.png]]
351 -
352 -Figure 3.3.19. Configuring object for control without entering password
353 -
354 -=== 3.3.2. Configuring permission for remote control ===
355 -
356 -Before executing control commands, some devices require an initial permission signal to be sent to a dedicated register. This signal enables telecontrol functionality. Only after this permission is granted the device accepts and process the main telecontrol commands.
357 -
358 -To implement this type of telecontrol (TC) in CENTO, the following attributes are added to the object class (see Fig. 3.3.20):
359 -
360 -* **telecontrol_permit_on_ti** – permission to switch TC on;
361 -* **telecontrol_permit_off_ti** – permission to switch TC off.
362 -
363 363  
Screenshot 2025-12-17 at 17.32.18.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.Lana
Size
... ... @@ -1,1 +1,0 @@
1 -121.9 KB
Content