Skip to Content

Changes for page 8. Control Setup Manual

Last modified by Iaroslav Platonov on 2026/06/09 11:18
From version 33.3
edited by Lana
on 2025/12/17 20:02
Change comment: There is no comment for this version
To version 33.2
edited by Lana
on 2025/12/17 20:00
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -269,15 +269,15 @@
269 269  
270 270  Figure 3.3.8. IM directory
271 271  
272 -IM settings allow sending both single and multiple remote control commands. Remote control is configured in the same way as control, but uses its own set of system commands.
272 +IM settings allow sending both single and multiple telecontrol commands. Telecontrol is configured in the same way as control, but uses its own set of system commands.
273 273  
274 -* **Single remote control command of an IM object**
274 +* **Single telecontrol command of an IM object**
275 275  
276 -If an IM object is intended for remote control from a diagram, the following system attributes are added to the object's class (see Fig. 3.3.9)
276 +If an IM object is intended for telecontrol from a diagram, the following system attributes are added to the object's class (see Fig. 3.3.9)
277 277  
278 278  [[image:Screenshot 2025-12-17 at 16.59.06.png]]
279 279  
280 -Figure 3.3.9. Adding remote control attributes to the Switch class
280 +Figure 3.3.9. Adding telecontrol attributes to the Switch class
281 281  
282 282  Values for these attributes should be specified for class elements (see Fig. 3.3.10):
283 283  
... ... @@ -286,5 +286,3 @@
286 286  * telecontrolled – flag indicating whether the object can be controlled (TRUTH – remote control is available, FALSE – not available).
287 287  
288 288  [[image:Screenshot 2025-12-17 at 16.59.40.png]]
289 -
290 -