Skip to Content

Changes for page 8. Control Setup Manual

Last modified by Iaroslav Platonov on 2026/06/09 11:18
From version 15.2
edited by Lana
on 2025/12/17 19:45
Change comment: There is no comment for this version
To version 13.2
edited by Lana
on 2025/12/17 19:42
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -135,19 +135,3 @@
135 135  The field **Byte order** from the drop-down list (see Fig. 3.1.6) is used to select different order of bytes and/or words in the written CENTO data.
136 136  
137 137  [[image:Screenshot 2025-12-17 at 16.42.23.png]]
138 -
139 -In the **Device Tag Data Type** field, select the data type used by the device to store values from the drop-down list (see the device manual for details) (see Fig. 3.1.7).
140 -
141 -[[image:Screenshot 2025-12-17 at 16.43.58.png]]
142 -
143 -Fig. 3.1.7. Device Tag Data Type
144 -
145 -In the **Transformation** block, a linear transformation is applied to convert a physical quantity into a value to be recorded, using defined upper and lower limits for both. These limits establish the valid ranges for the physical quantity and its corresponding recorded value, within which data can be filled in (see Fig. 3.1.8).
146 -
147 -[[image:Screenshot 2025-12-17 at 16.44.29.png]]
148 -
149 -Figure 3.1.8. Transformation block
150 -
151 -In devices using the OPC DA protocol, the control function is easier to configure. In the settings, enable **Write values**, select the device tag data type, and define the necessary transformations (see Fig. 3.1.9).
152 -
153 -
Screenshot 2025-12-17 at 16.43.58.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.Lana
Size
... ... @@ -1,1 +1,0 @@
1 -32.6 KB
Content
Screenshot 2025-12-17 at 16.44.29.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.Lana
Size
... ... @@ -1,1 +1,0 @@
1 -27.1 KB
Content