Changes for page 8. Control Setup Manual
Last modified by Iaroslav Platonov on 2026/06/09 11:18
Summary
-
Page properties (1 modified, 0 added, 0 removed)
-
Attachments (0 modified, 0 added, 2 removed)
Details
- Page properties
-
- Content
-
... ... @@ -113,25 +113,3 @@ 113 113 Figure 3.1.3. Setting control for Modbus protocol 114 114 115 115 [[image:Screenshot 2025-12-17 at 16.41.11.png]] 116 - 117 -Figure 3.1.4. Remote control for IEC-104 118 - 119 -Settings for writing: Write values, Function, Device Tag Data Type, Address, Byte order; Tranformation elements: Physical value (lower limit), Physical value (upper limit), Record value (lower limit), Record value (upper limit). 120 - 121 -The position of the **Write values** switch determines whether value write commands can be sent to the device at the specified address. 122 - 123 -The **Function** field selects the Modbus recording function from the drop-down list (see Fig. 3.1.5). 124 - 125 -[[image:Screenshot 2025-12-17 at 16.41.51.png]] 126 - 127 -Figure 3.1.5. Modbus control function 128 - 129 -FC5 (0x05) - recording the value of one flag (Force Single Coil). 130 - 131 -FC16 (0x10) - recording multiple registers, used to write a block of contiguous registers (1 to 123 registers) to a remote device (Write multiple registers). 132 - 133 -The **Address** field specifies the address of the tag in the device memory to which the value will be written. The address should be a non-negative integer in decimal format. 134 - 135 -The field **Byte order** from the drop-down list (see Fig. 3.1.6) is used to select different order of bytes and/or words in the written CENTO data. 136 - 137 -[[image:Screenshot 2025-12-17 at 16.42.23.png]]
- Screenshot 2025-12-17 at 16.41.51.png
-
- Author
-
... ... @@ -1,1 +1,0 @@ 1 -XWiki.Lana - Size
-
... ... @@ -1,1 +1,0 @@ 1 -12.4 KB - Content
- Screenshot 2025-12-17 at 16.42.23.png
-
- Author
-
... ... @@ -1,1 +1,0 @@ 1 -XWiki.Lana - Size
-
... ... @@ -1,1 +1,0 @@ 1 -32.3 KB - Content