Changes for page 8. Control Setup Manual

Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -113,3 +113,27 @@
113	113	Figure 3.1.3. Setting  control for Modbus protocol
114	114
115	115	[[image:Screenshot 2025-12-17 at 16.41.11.png]]
	116	+
	117	+Figure 3.1.4. Remote control for IEC-104
	118	+
	119	+Settings for writing: Write values, Function, Device Tag Data Type, Address, Byte order; Tranformation elements: Physical value (lower limit), Physical value (upper limit), Record value (lower limit), Record value (upper limit).
	120	+
	121	+The position of the **Write values** switch determines whether value write commands can be sent to the device at the specified address.
	122	+
	123	+The **Function** field selects the Modbus recording function from the drop-down list (see Fig. 3.1.5).
	124	+
	125	+[[image:Screenshot 2025-12-17 at 16.41.51.png]]
	126	+
	127	+Figure 3.1.5. Modbus control function
	128	+
	129	+FC5 (0x05) - recording the value of one flag (Force Single Coil).
	130	+
	131	+FC16 (0x10) - recording multiple registers, used to write a block of contiguous registers (1 to 123 registers) to a remote device (Write multiple registers).
	132	+
	133	+The **Address** field specifies the address of the tag in the device memory to which the value will be written. The address should be a non-negative integer in decimal format.
	134	+
	135	+The field **Byte order** from the drop-down list (see Fig. 3.1.6) is used to select different order of bytes and/or words in the written CENTO data.
	136	+
	137	+[[image:Screenshot 2025-12-17 at 16.42.23.png]]
	138	+
	139	+In the **Device Tag Data Type** field, select the data type used by the device to store values from the drop-down list (see the device manual for details) (see Fig. 3.1.7).